Simpson PS4240H Instruction Manual download pdf (Page 14)

14- ENG

To Apply chemicals:

1. Ensure detergent siphon hose (F, Figure 7) is attached

to barbed fitting location near high pressure hose

connection of pump as shown.

2. Place other end of detergent siphon hose with

filter on it into container holding chemical/cleaning

solution. NOTE: For every 7 gallons of water pumped

1 gallon of chemical/cleaning solution will be used.

3. Install low pressure (black) nozzle into quick connect

fitting of spray wand, see How To Use Spray Wand paragraph in this section.

4. After use of chemicals, place detergent siphon hose into container of clean

water and draw clean water through chemical injection system to rinse system

thoroughly. If chemicals remain in the pump it could be damaged. Pumps

damaged due to chemical residue will not be covered under warranty.

NOTE: Chemicals and soaps will not siphon if the black soap nozzle is not installed

on the spray wand.

STARTING (FIG. 8–11)

WARNING: To reduce the risk of injury, read the pressure washer instruction

manual and the engine instruction manual before starting pressure washer.

DANGER: Risk of fluid injection and laceration. When using the high-

pressure setting, DO NOT allow the high-pressure spray to come in contact

with unprotected skin, eyes, or with any pets or animals. Serious injury will

occur.

• Your washer operates at fluid pressures and velocities high enough to penetrate

human and animal flesh, which could result in amputation or other serious injury.

Leaks caused by loose fittings or worn or damaged hoses can result in injection

injuries. DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a physician

immediately!

WARNING: Risk of Fire, Asphyxiation and Burn. Never fill fuel tank when

engine is running or hot. Do not smoke when filling fuel tank.

• Never fill fuel tank completely. Fill tank to 1/2" )12.7mm) below bottom of filler

neck to provide space for fuel expansion. Wipe any fuel spillage from engine and

equipment before starting engine.

• Never run engine in doors or in en closed, poorly ven ti lat ed areas. En gine exhaust

con tains carbon mon ox ide, an odorless and deadly gas.

• DO NOT let hoses come in contact with very hot engine muffler during or

immediately after use of your pressure washer. Damage to hoses from contact with

hot engine surfaces will NOT be covered by warranty.

NOTICE: Risk of property damage. Never pull water supply hose to move pres sure

washer. This could damage hose and/or pump inlet.

• DO NOT use hot water, use cold water only.

• Never turn water supply off while pressure washer engine is running or damage to

pump will result.

• DO NOT stop spraying water for more than two minutes at a time. Pump operates

in bypass mode when spray gun trigger is not pressed. If pump is left in bypass

mode for more than two minutes internal components of the pump can be

damaged.

If you do not understand these precautions, please contact our customer service

department at www.simpsoncleaning.com!

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Comments to this Manuals

No comments

Simpson PS4240H Instruction Manual Page 14

Comments to this Manuals

Related products and manuals for High-pressure cleaners Simpson PS4240H